Plug and Play 2.4GHz, complies with 802.11g/n standards to insure interoperability, 250mW High Power Wireless Bridge System. Up to 8 miles apart with good line of sight. Providing realworld thruput up to 100Mbps.
100Mbps and 8 miles or more with good line of sight!
802.11n MIMO TDMA
The EZ-Bridge®-Ultra2-LR is a high capacity 100Mbps and high power 250mW outdoor wireless bridge system operating in the 2.4GHz unlicensed spectrum. The complete system allows for ultra high bandwidth connections between two buildings up to 8 miles or more apart with good line of sight. The 2.4GHz frequency gives better performance when dealing with trees or marginal line of sight installations.
The EZ-Bridge®-Ultra2-LR creates a transparent bridge between two sides and passes all network traffic including VPN and DHCP. You can think of it like connecting a CAT5 Ethernet cable between the two points.
It is the perfect high capacity plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-Bridge®-Ultra2-LR units can be connected in a mesh configuration to allow interconnecting more than two sites.
The system supports 802.11n TDMA and 802.11g OFDM for backward compatibility. The advanced MIMO antenna system offers 18dBi of gain in a compact and visually pleasing package. The antenna also offers great front to back performance which helps reduce interference. A snap-on radome is included to protect the antenna from snow, ice, hail and crazy birds who sometimes like to nest in antennas.
With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.
Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power supplies. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that need to be loaded to the computer.
The corrosion resistant bracket system allows mounting to a pole with up to 2.25" diameter or wall mounting using the included wall mount brackets. The bracket provides +/- 20 degrees vertical tilt and unlimited horizontal adjustment. The system comes with Power Over Ethernet power inserters and two rolls of shielded and outdoor rated 75' long CAT5 cable assemblies. The shielded outdoor cable helps to protect against EMI from lightning and ESD from wind.
The EZ-Bridge®-Ultra2-LR comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including two powerful 18dBi 802.11g/n MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Two Cat5e rated PoE (Power Over Ethernet) power inserters and two 75' Shielded Outdoor Rated CAT5 cable assemblies.
The EZBR-0516+ management interface is IPv6 enabled, https enabled. Logon username is fixed. The password can be changed, and there are no rules for password length or content.
SPEC SHEET | USER GUIDE